• 0:59

    Very rarely do the gasket holes line up with bolt holes when you are replacing valve cover gaskets. Brent Ackley teaches a helpful trick to properly align these holes. Use this method to make sure you have a good seal.

    Watch Now >>
  • 2:44

    Brent Ackley and George Vondriska have a new project to work on, a 1977 El Camino. Mechanically the El Camino is in good shape but the body is in poor shape. The body is what they plan to focus on. Brent and George will be providing lessons on how to work around the fact that you can’t readily find body parts

    Read more »

    Watch Now >>
  • How to Install a Cold Air Intake for your Car
    14:13

    Amir Rosenbaum teaches you the three aspects that you can utilize to add power to your car – fuel, spark and air. For a car’s performance, hot air is bad and cool air is good. Amir demonstrates how to install a cold air intake kit that adds 1% horsepower for every 10 degree drop in

    Read more »

    Watch Now >>
  • 15:05

    Cam Benty shows off a stunning 1968 327 Camaro and discusses how the car engine area underneath the hood can look even better. He previews all sorts of chrome parts, including valve covers, an air cleaner, spark plug wire holders and more, that will make your classic car engine really shine.

    Watch Now >>
  • 17:38

    If you hit the gas and your classic car goes “vroom, vroom”, but you’re still not moving, it’s time for a clutch replacement. Brent Ackley and George Vondriska show you how to take out the drive shaft and unbolt a majority of the transmission on your car’s engine to remove and replace the clutch.

    Watch Now >>
  • 14:12

    Brent Ackley teaches you how to properly assemble a classic car engine at your own pace, with in-depth instructions for installing the crank and cam shafts, inserting the main oil bearings, assembling and removing the pistons and putting the timing cover on.

    Watch Now >>
  • Overview of the Rebuilt 350 Classic Car Engine
    4:06

    Brent Ackley gives you an overview of a rebuilt 350 4 Bolt Main classic car engine that can run pump gas and now has 325-350 HP. He starts by sending the engine to the auto shop for close cleaning, measuring, and overall renewal.

    Watch Now >>
  • 2:24

    George Vondriska teaches how to use a pressurized device to test the performance of your classic car’s radiator system and radiator cap to prevent the parts from leaking. Also see how this technique prevents the engine of your classic car from overheating.

    Watch Now >>
  • Replacing an Oil Pan Gasket
    8:09

    Nobody likes an oil drip! George Vondriska shows you how to reach and replace the oil pan on a 1977 Chevy 454. Before recording the video, he drained the oil from the pan and removed the filter to get access to the oil filter adapter. Use these helpful tips presented to replace the oil pan

    Read more »

    Watch Now >>