• 2:39

    Brent Ackley teaches you how to prime the oil system on a 1956 Chevrolet 150, demonstrating each of the essential classic car maintenance tips and techniques you’ll utilize to get the system properly up and running. He shows you how to use an air wrench to get the oil spread evenly before dropping in a

    Read more »

    Watch Now >>
  • 3:24

    Craig Hopkins covers the three types of welding basics. He teaches you how to stabilize, distance, and consistently push the bead in a lap weld. For a plug weld, you will learn to start outside the circle and bring it in just licking the edges. Lastly, the butt weld will teach you to move the

    Read more »

    Watch Now >>
  • 2:02

    Add the finishing touches to your full car floor installation with Craig Hopkins. He tells you that the plug welds don’t necessarily have to be ground down, but if you’re going to what tools to use. He uses a cut off wheel with a 3/8th wide rock and 3 inch angle grinder with a 36

    Read more »

    Watch Now >>
  • Review & Using Weld Through Primer
    1:16

    Craig Hopkins gives a review of his preferred weld through primer – Medallions rubberseal RS512. He claims this is the best weld through primer he has ever used despite what others say. See how to apply a thin coat to the bottom of the panel.

    Watch Now >>
  • Removing the Emergency Brake Cable from a Car
    1:12

    Craig Hopkins quickly teaches you how to use a clamp and a rubber mallet to remove an emergency brake cable from its holding in the floor of a car body.

    Watch Now >>
  • 5:20

    When stripping the hardware from a car, it is important that you take the necessary precautions to carefully remove each component. Craig Hopkins teaches you how to use a torch and a few hand tools to find and remove screws and other materials that are holding the hardware onto the body of the car. The

    Read more »

    Watch Now >>
  • 24:51

    Here is a great technical tips segment for those doing bodywork and getting ready for paint. Learn how to load and adjust sanding blocks and more. Watch as Aaron Hopkins demonstrates block sanding techniques that allow you to get your car as smooth as glass!

    Watch Now >>
  • 0:59

    Very rarely do the gasket holes line up with bolt holes when you are replacing valve cover gaskets. Brent Ackley teaches a helpful trick to properly align these holes. Use this method to make sure you have a good seal.

    Watch Now >>
  • Tip - Window Trim Fuzzy Fix
    2:28

    Learn a few helpful tips for fixing a fuzzy window trim piece. Craig Hopkins demonstrates the little things that can be done to help make the window trim lay in the car better. Not only will it make the car look cool, it also helps with the side glass.

    Watch Now >>