• 8:01

    When restoring a classic car there are some areas that are nearly impossible to get to. One of those areas is inside the rocker panels and frame rails. Let’s face it if your classic car still has it’s original rocker panel sheet metal, you want to do everything you can to keep it that way.

    Read more »

    Watch Now >>
  • 1:36

    Nothing is more frustrating than chipping fresh paint while attaching trim screws. Mark Simpson demonstrates a quick and easy way to use dielectric grease to avoid chipped paint mishaps and finish your classic car off right.

    Watch Now >>
  • 3:51

    Rusty cast iron exhaust manifolds or even master cylinders can be a distraction in a neatly detailed engine compartment. Paint and many high-heat coatings often don’t last in this environment and when they start to chip, peel and burn they often look even worse. Mark Simpson demonstrates how to freshen up the look of the

    Read more »

    Watch Now >>
  • 3:06

    Knowing the correct way to mix body filler is important in achieving consistently good results without pinholes and air pockets. Mark Simpson shows us the correct process and explains why it is important to use the correct ratios of Filler and Hardener to avoid corrosion and achieve a good bond.

    Watch Now >>
  • 3:13

    Removing decals from car and trim tape adhesives can seem impossible without damaging the underlying paint. Gary Simpson demonstrates how the process can be done safely and effectively using a tool known as an eraser wheel. Knowing how to use this tool properly will help you safely remove even vintage decals without scratching the paint.

    Watch Now >>
  • 1:12

    Creating square cuts on round tubing with hand tools can be challenging. Metal fabricator Gary Simpson demonstrates the process of laying out straight and square lines on round tubing and how to cut them.

    Watch Now >>
  • 2:35

    Fish mouthing is a process of creating a weldable joint when joining two pieces of round tubing, while jigs are available to simplify the process, Gary Simpson demonstrates how to create quality fish mouth tube joints using simple hand-tools.

    Watch Now >>
  • 0:00

    Often overlooked, welding metal prep is key to achieving good looking and strong welds with proper penetration. Metal fabricator Gary Simpson, explains the importance of properly cleaning metal and demonstrates how to remove mill scale to create stronger welds.

    Watch Now >>
  • 9:48

    Proper setup of your MIG welding equipment is the first step in achieving good MIG welds. Metal fabricator Gary Simpson demonstrates how to setup your welder, shielding gas, your workspace, and replace consumables on your welder.

    Watch Now >>