• How to Sandblast a Car Wheel
    2:54

    How to Sandblast a Car Wheel

    Brent Ackley has taken a wheel off the El Camino and will scale the rust out to get it ready to prime and paint. He goes over several different kinds of sandblasters and also covers the different types of media that can be used to blast. Use these helpful tips to sandblast a wheel.

    Watch Now >>
  • How To Remove a Landau Top 
    4:26

    How to Remove a Landau Top 

    In this video, find out how to properly and efficiently remove a landau top. Brent Ackley goes through each step of the process. Removing the windshield trim and side trim is the first step. Learn helpful tips for removing your own landau top!

    Watch Now >>
  • Classic Car Body Work: Painting
    5:57

    Classic Car Body Work: Painting

    In the final installment of our five-part series on upgrading your classic car’s body work, Brent Ackley teaches you how to properly spray a basecoat of paint onto a door panel. He stresses the importance of following the instructions for a specific type of paint, and then demonstrates the spraying process for the first coat…

    Watch Now >>
  • 3:07

    Classic Car Body Work: Sanding

    In the fourth installment of our five-part series on upgrading your classic car’s body work, Brent Ackley teaches you a few tips for properly sanding the surface of a door panel in preparation for the paint job. He uses 400 grit wet sandpaper on a sanding block, and demonstrates the tedious but necessary process of…

    Watch Now >>
  • Classic Car Body Work: Primer
    8:02

    Classic Car Body Work: Primer

    In the third installment of our five-part series on upgrading your classic car’s body work, Brent Ackley teaches you how to properly mix a two-part primer and apply three coats of the mixture to a door panel. He demonstrates each of the steps you’ll need to complete in preparation for priming, and then shows the…

    Watch Now >>
  • 8:24

    Classic Car Body Work: Stripping and Plastic Filler

    In the second installment of our five-part series on upgrading your classic car’s body work, Brent Ackley teaches you how to properly strip paint from and rough up a door panel, and then mix and apply plastic filler. He demonstrates each of the techniques that you’ll need to complete the process and achieve a uniform…

    Watch Now >>
  • Classic Car Body Work: Getting Started
    4:26

    Classic Car Body Work: Getting Started

    George Vondriska and Brent Ackley begin the process of repairing a door panel for a 1956 Chevrolet 150. They teach about all of the steps that you’ll need to complete to repair a classic car body, including stripping the original paint, priming the surface with epoxy, sanding for uniformity, and repainting with several coats.

    Watch Now >>
  • 3:16

    1956 Chevy 150 Complete Auto Repair Overview

    George Vondriska and Brent Ackley give you a brief rundown of the 1956 Chevrolet 150 that Brent brought into the shop for a complete auto repair. Before they get started on fixing up the classic car, the guys talk about some of the specifications of this model and discuss a few of the cost-effective ways…

    Watch Now >>
  • Welding Tips: Floorpan Lap & Butt Welds
    4:05

    Welding Tips: Floorpan Lap and Butt Welds

    Craig Hopkins uses his helmet cam to give you an up-close look of the timing, spacing and location of a proper weld. He starts by using a 3 inch grinder to flatten welds out, and then shows you how to create lap and butt welds that are four beads long. Use this helpful welding tips…

    Watch Now >>