• Vehicle Floorpan Welding Basics & Examples
    5:48

    Craig Hopkins provides you with awesome welding basics while he gets you off the tool bench and welds a floorpan into a classic car. He starts by applying a RS512 primer by Rubberseal that will give you a longer lasting repair, and then teaches you how to tightly and safely clamp the floorpan down.

    Watch Now >>
  • 4:06

    Craig Hopkins teaches you how to properly use and take care of a welder. Personally, he likes to work with the gas gauge on 30, but for better puddle control you’ll work on 20. No matter what type of welder you have, make sure to maintain a nice gentle loop in all of the cords

    Read more »

    Watch Now >>
  • Welder Selection: Different Types of Welders
    3:42

    Craig Hopkins provides helpful insight into the different types of welders available. He helps you decide what type of welder to buy by reviewing a 110 tap unit and a 220V 175 gas shielded unit. He recommends the 220V unit over the 210V, but discusses how both will get the job done. Just don’t get

    Read more »

    Watch Now >>
  • 2:25

    George Vondriska introduces you to the combination impact wrench and wheel torque extension, which ranges from 55 pounds of torque to 140 pounds of torque. You will learn how to get a perfectly consistent torque throughout by using a cross pattern technique.

    Watch Now >>
  • 2:20

    If you have zerks on your classic car, you should know that you’ll need to grease them whenever you complete an oil change. Sometimes they do not want to take the grease, so Brent Ackley recommends using zerk busters. See how helpful these handy helpers can be for classic cars. Zerk Busters can be found

    Read more »

    Watch Now >>
  • Classic Car Maintenance: Using a Klecko
    0:57

    Mark Oja demonstrates how easy it is to install and remove the Cleco, a tool that most classic car maintenance professionals use to easily and effectively joint sheet metal panels on their cars.

    Watch Now >>
  • 1:28

    A sheet metal shrinker/stretcher is perfect for any type of metal fabrication you need for your classic car, and it keeps the metal completely flat (without crimps). Mark Oja gives a brief demonstration on how the stretcher works and then shows you an example of a finished product.

    Watch Now >>
  • Classic Car Sanding Supplies in Your Shop
    2:10

    Sanding is a critical step in adding an impressive paint job to your classic car, so you need the proper supplies in your shop. Cam Benty helps you chose what size blocks to use, how to build your own block and the functions of a powder can. A proper finish starts with the car sanding

    Read more »

    Watch Now >>
  • 16:01

    The Bead Roller is a handy tool that provides extra strength by adding ridges to your sheet metal. Mark Oja and Cam Benty demonstrate how to use a Bead Roller on your classic car to add a little extra flair and strength to any metal you have.

    Watch Now >>