Tank Strap Cushions



I have a ’53 Pontiac and am replacing the gas tank. The old tank had cloth straps that fit under the metal straps and between the tank and body. Your video for the 57 Desoto gas tank replacement showed no such cloth straps. What purpose did they serve and are they necessary?


Many cars used a cushion between the straps and the tank also between the tank and the frame/body. Their purpose primarily is to prevent squeaking. Whenever two pieces of metal are in contact with each other there is the potential of them rubbing and squeaking.

I have seen some cars over the years that were designed in such a manner as when the cushion is removed the tank fits loosely in the straps, however this is uncommon. The ’57 DeSoto you mentioned used no cushions originally and the tank fits tightly in the straps.

If you are absolutely committed to a accurate restoration, I would encourage you to replace them with similar material. If not, your car should be fine without them as long as the tank fits tightly when installed. If you do decide to reinstall the cushion material, I would consider replacing it with rubber, as the old canvas type hold moisture and in time look shabby as the material gets exposed to dirt and water.

Here you’ll find a link to a source for rubber tank strap material.

Wrench Safe,
– Mark

Share tips, start a discussion or ask one of our experts or other students a question.

Make a comment:
500 characters remaining

2 Responses to “Tank Strap Cushions”

  1. Michael C

    I've used Gorilla tape or fiberglass strapping. I use it in case there are sharp edges on the straps that can cut or wear holes in my tank. Keep in mind, if you insulate the tank a good ground for the sending unit must be in place, too.

  2. joe enesser

    I have had tank straps fail. This was from rust and found that the area between strap and tank also had rusted. some ideas to consider: 1. paint the tank and staps with a rust type inhibitor, and the total surfaces. Let set until totally dried and if need be recoat. 2. use a rubber strip to isolate noise and ware vibrations. You can purchase or if you have any old bike or car tire inner tubes, these cut to fit would work. 3. use some rubber cement to hold the strips to straps for installation. You may find other metods and ideas. Good luck.