When working with body fillers the resins tend to migrate to the surface as the body filler cures. These resins can quickly clog a new sheet of sandpaper. Here is a quick tip for cleaning sandpaper and getting it unclogged. This will have you sanding again without the expense of a new sheet of sandpaper.
You Might Also Enjoy...
-
5:18How to Tig Weld: Welding Aluminum
TIG (Tungsten Inert Gas) welding aluminum can take a little more practice to perfect. Professional hot rod fabricator and welder, Gary Simpson, takes us through the process from preparing the torch and electrode, to correct welder settings, to proper metal preparation and finally the welding process itself. You’ll see first hand how with the right…
Watch Now >> -
4:05Welding Tips: Floorpan Lap and Butt Welds
Craig Hopkins uses his helmet cam to give you an up-close look of the timing, spacing and location of a proper weld. He starts by using a 3 inch grinder to flatten welds out, and then shows you how to create lap and butt welds that are four beads long. Use this helpful welding tips…
Watch Now >> -
3:42Welder Selection: Different Types of Welders
Craig Hopkins provides helpful insight into the different types of welders available. He helps you decide what type of welder to buy by reviewing a 110 tap unit and a 220V 175 gas shielded unit. He recommends the 220V unit over the 210V, but discusses how both will get the job done. Just don’t get…
Watch Now >> -
6:00Bending Brake Lines and Creating Inverted Flares on Brake Tubing
Cutting, bending, and creating inverted flares on brake lines is a necessary skill when building a classic car. Mark Simpson takes us through the process step by step so you’ll be prepared to build your own custom brake lines.
Watch Now >>
