Craig Hopkins gives another demonstration on plasma cutting. He shows you how to save a part that will be bracketed back into the classic car perfectly. You will learn to replace the rear footwell on top of floor pan, cut behind it, and avoid seat bases and rockers.
You Might Also Enjoy...
-
8:49How to Sand a Car: DA Sanding
Craig Hopkins demonstrates how to sand a car fender using a small, tight orbit DA with a cushion pad. This allows for a nice flow rate that makes the sanding really smooth and gives the classic car a clean finish. Make sure to be just as careful Craig when sanding around the edges so you…
Watch Now >> -
12:25Restoring a Classic Car: Installing Fenders
Craig Hopkins provides helpful tips for restoring a classic car in this video. He explains that it is imperative the doors on a classic car are lined up before installing the fenders because that’s what the fenders are going to fit. The control bolt will then set the height of fender to height of door…
Watch Now >> -
6:41Classic Car Quarter Panel Removal
Craig Hopkins and Randy Bolig take you through a classic car quarter panel removal process. First, they outline with a black marker what they are going to cut out of a 1969 Dodge Dart. Then they use a torch and brush to get lead out of the car, which shows them exactly where to cut.…
Watch Now >> -
12:05Classic Car Restoration: Cut-Down Techniques
Craig Hopkins gives you different tips and tricks to help cut down the metal on a classic car panel without damaging the base. You must make sure to push the metal over weld, rather than attacking it, to avoid tearing the base metal. You will also learn how to get spot welds out. Use this…
Watch Now >>
