Brent Ackley and George Vondriska continue going through the motor assembly process by installing the intake and the valve covers on the motor of a 1986 Chevy pickup that they’ll put into a 1956 Chevrolet 150. They teach you all of the important classic car maintenance tips and techniques that you’ll need, including how to properly mount, tighten and torque gaskets, intake covers and valve covers onto the motor head.
You Might Also Enjoy...
-
4:01Classic Car Maintenance Tips: Timing the Engine
Brent Ackley teaches you how to correctly install a distributor into the engine of a 1956 Chevrolet 150, walking you step by step through the process and demonstrating the essential classic car maintenance tips and techniques you’ll need to utilize. He shows the proper method for opening the intake valves in order to drop in…
Watch Now >> -
5:33Classic Car Distributor Cap Inspection
George Vondriska visually inspects each part of the distributor cap – the cap itself, the router, and the points. He shows what corrosion on the inside of a used cap looks like compared to a new, working one, discusses the different types of routers and teaches you how to set the point cap with a…
Watch Now >> -
0:59Aligning Valve Cover Gaskets With Bolt Holes
Very rarely do the gasket holes line up with bolt holes when you are replacing valve cover gaskets. Brent Ackley teaches a helpful trick to properly align these holes. Use this method to make sure you have a good seal.
Watch Now >> -
17:09U-Joint Replacement For a Classic Car
You’re probably well aware that hearing a “clunk” sound when shifting your car into gear is never good, but did you know that it typically means you may need a U-Joint replacement? Brent Ackley discusses the bearings that are causing this problem and shows how to replace them.
Watch Now >>
