In this video, learn how to customize your own classic car! Sheet Metal Fabrication can be a useful and effective tool when you are looking to add customized exterior to your classic car. Mark Oja works on a rare, custom Blown Fiat and adds his own custom hood using sheet metal fabrication made from cheap sheet metal.
You Might Also Enjoy...
-
12:25Craig Hopkins provides helpful tips for restoring a classic car in this video. He explains that it is imperative the doors on a classic car are lined up before installing the fenders because that’s what the fenders are going to fit. The control bolt will then set the height of fender to height of door…
Watch Now >> -
18:30Craig Hopkins explains how to sand a car with a paint stick around the edges without making a flat spot. He uses the water blade to distinguish where to sand more and where not to over sand. You will get an up close look on how to properly sand every difficult area, crease, and edge.
Watch Now >> -
8:49Craig Hopkins demonstrates how to sand a car fender using a small, tight orbit DA with a cushion pad. This allows for a nice flow rate that makes the sanding really smooth and gives the classic car a clean finish. Make sure to be just as careful Craig when sanding around the edges so you…
Watch Now >> -
9:32Craig Hopkins runs down a checklist on how a car quarter panel should fit on your classic car, including using plenty of clamps and securing it with a final welding and rock grinder to level it out for a perfect repair.
Watch Now >>
