The Bead Roller is a handy tool that provides extra strength by adding ridges to your sheet metal. Mark Oja and Cam Benty demonstrate how to use a Bead Roller on your classic car to add a little extra flair and strength to any metal you have.
You Might Also Enjoy...
-
15:42Customize Your Own Classic Car With Sheet Metal Fabrication
In this video, learn how to customize your own classic car! Sheet Metal Fabrication can be a useful and effective tool when you are looking to add customized exterior to your classic car. Mark Oja works on a rare, custom Blown Fiat and adds his own custom hood using sheet metal fabrication made from cheap…
Watch Now >> -
9:32Classic Car Quarter Panel Final and Welding
Craig Hopkins runs down a checklist on how a car quarter panel should fit on your classic car, including using plenty of clamps and securing it with a final welding and rock grinder to level it out for a perfect repair.
Watch Now >> -
6:36Welding the Wheel Panel on Your Project Car
Craig Hopkins teaches you how to fit and weld the wheel panel on your project car in the wheelhouse. He uses a spot welder even though a plug weld works just as well for this type of job.
Watch Now >> -
8:49How to Sand a Car: DA Sanding
Craig Hopkins demonstrates how to sand a car fender using a small, tight orbit DA with a cushion pad. This allows for a nice flow rate that makes the sanding really smooth and gives the classic car a clean finish. Make sure to be just as careful Craig when sanding around the edges so you…
Watch Now >>
