Are you ready to apply epoxy primer to your project? Watch as Aaron Hopkins prepares the epoxy and demonstrates how to use the gun. He also identifies common problems you can encounter when setting up your gun. Learn what pattern and overlap Aaron uses to obtain even coverage as he applies the epoxy primer. The end result is a nicely sealed and protected panel!
You Might Also Enjoy...
-
8:49Craig Hopkins demonstrates how to sand a car fender using a small, tight orbit DA with a cushion pad. This allows for a nice flow rate that makes the sanding really smooth and gives the classic car a clean finish. Make sure to be just as careful Craig when sanding around the edges so you…
Watch Now >> -
9:32Craig Hopkins runs down a checklist on how a car quarter panel should fit on your classic car, including using plenty of clamps and securing it with a final welding and rock grinder to level it out for a perfect repair.
Watch Now >> -
1:04Craig Hopkins teaches you how to sharpen a chisel on a bench grinder with ease in this video. To get a single edge chisel, you simply lay it on the stone and create a sharp edge and a cup.
Watch Now >> -
1:28A sheet metal shrinker/stretcher is perfect for any type of metal fabrication you need for your classic car, and it keeps the metal completely flat (without crimps). Mark Oja gives a brief demonstration on how the stretcher works and then shows you an example of a finished product.
Watch Now >>
