Fish mouthing is a process of creating a weldable joint when joining two pieces of round tubing, while jigs are available to simplify the process, Gary Simpson demonstrates how to create quality fish mouth tube joints using simple hand-tools.
You Might Also Enjoy...
-
2:39Classic Car Detailing: Cleaning the Engine Compartment
Classic car detailing has never been easier! Brent Ackley and George Vondriska teach you how to clean the engine compartment on a 1956 Chevy 210. After a reasonable power wash, scuff sand, prime and paint, the engine compartment on your classic car should look ready for the showroom.
Watch Now >> -
7:41Classic Car Polishing Preparation
Craig Hopkins prepares you to polish your classic car with 1000, 1500, and 3000 grit sandpaper without scratching the paint, and then shows you the sanding technique with paint sticks, blocks, and a water blade to get the perfect finish. Make sure all of your equipment is clean!
Watch Now >> -
18:30How to Sand a Car: Hand Sanding
Craig Hopkins explains how to sand a car with a paint stick around the edges without making a flat spot. He uses the water blade to distinguish where to sand more and where not to over sand. You will get an up close look on how to properly sand every difficult area, crease, and edge.
Watch Now >> -
0:56Replacing Bolts on Classic Muscle Cars
Because classic muscle cars are usually older, their owners typically have to replace bolts more often than those of modern cars. Mark Oja teaches you two ways to do so, with one being more costly than the other. Once you determine that the bolts you removed are correct, Mark suggests buying a complete bolt replacement…
Watch Now >>
