George Vondriska walks you through the process of hanging a car door. See what utilities are required and how to properly connect a door to a vehicle. Use these helpful tips for hanging a car door and make sure you have an extra pair of hands before you get to work.
You Might Also Enjoy
-
3:34Essential Car Tools
Craig Hopkins introduces the car tools you will need to install front sheet metal to your classic car. Some of the equipment you will need includes a ratcheting strap, screw driver, wrench, ratchet, sockets, hammer and pick bar. New hinges will also help make the hood fall in the same place every time.
Watch Now >> -
18:30How to Sand a Car: Hand Sanding
Craig Hopkins explains how to sand a car with a paint stick around the edges without making a flat spot. He uses the water blade to distinguish where to sand more and where not to over sand. You will get an up close look on how to properly sand every difficult area, crease, and edge.
Watch Now >> -
3:30Trial Fitting on the Classic Car Quarter Panel
Since you will butt weld the new quarter panel to the roof and existing quarter panel, Craig Hopkins teaches you how to remove a quarter of an inch from the roof without cutting through the existing car quarter panel. Then, he’ll apply some weld through primer to the step you just created and rest the…
Watch Now >> -
12:05Classic Car Restoration: Cut-Down Techniques
Craig Hopkins gives you different tips and tricks to help cut down the metal on a classic car panel without damaging the base. You must make sure to push the metal over weld, rather than attacking it, to avoid tearing the base metal. You will also learn how to get spot welds out. Use this…
Watch Now >>
