Brent Ackley teaches you how to properly assemble a classic car engine at your own pace, with in-depth instructions for installing the crank and cam shafts, inserting the main oil bearings, assembling and removing the pistons and putting the timing cover on.
You Might Also Enjoy...
-
17:38Classic Car Clutch Replacement
If you hit the gas and your classic car goes “vroom, vroom”, but you’re still not moving, it’s time for a clutch replacement. Brent Ackley and George Vondriska show you how to take out the drive shaft and unbolt a majority of the transmission on your car’s engine to remove and replace the clutch.
Watch Now >> -
4:01Classic Car Maintenance Tips: Timing the Engine
Brent Ackley teaches you how to correctly install a distributor into the engine of a 1956 Chevrolet 150, walking you step by step through the process and demonstrating the essential classic car maintenance tips and techniques you’ll need to utilize. He shows the proper method for opening the intake valves in order to drop in…
Watch Now >> -
1:01Tips for Timing the Engine of a Classic Car
Brent Ackley teaches you how to time an engine for a classic car. He explains that all you need is ordinary chalk to mark the timing marks between the harmonic balancer and timing grid.
Watch Now >> -
0:59Aligning Valve Cover Gaskets With Bolt Holes
Very rarely do the gasket holes line up with bolt holes when you are replacing valve cover gaskets. Brent Ackley teaches a helpful trick to properly align these holes. Use this method to make sure you have a good seal.
Watch Now >>
