Brent Ackley and George Vondriska begin the classic car motor assembly process in this video. First, they mount and bolt down a gasket head for the motor of a 1986 Chevy pickup truck that they will put into a 1956 Chevrolet 150. They teach you the expert techniques that you can utilize to guarantee that your own gasket head is installed properly.
Tags: Premium Videos
You Might Also Enjoy...
-
17:09You’re probably well aware that hearing a “clunk” sound when shifting your car into gear is never good, but did you know that it typically means you may need a U-Joint replacement? Brent Ackley discusses the bearings that are causing this problem and shows how to replace them.
Watch Now >> -
1:48George Vondriska teaches you how to find the correct gaps between points on your car engine. He starts by showing you how to create the largest gap possible between points. This will not give you the perfect gap, but allows for your classic car to run. Then, he teaches you how to maneuver the gaps to find the perfect
Watch Now >> -
0:59Very rarely do the gasket holes line up with bolt holes when you are replacing valve cover gaskets. Brent Ackley teaches a helpful trick to properly align these holes. Use this method to make sure you have a good seal.
Watch Now >> -
17:38If you hit the gas and your classic car goes “vroom, vroom”, but you’re still not moving, it’s time for a clutch replacement. Brent Ackley and George Vondriska show you how to take out the drive shaft and unbolt a majority of the transmission on your car’s engine to remove and replace the clutch.
Watch Now >>
