Brent Ackley teaches you how to install a new carburetor into a 1956 Chevrolet 150. He walks you step by step through the installation process, demonstrating the essential classic car maintenance tips and techniques you’ll utilize for this classic car restoration process, including properly aligning, bolting and torqueing the component.
You Might Also Enjoy...
-
17:38Classic Car Clutch Replacement
If you hit the gas and your classic car goes “vroom, vroom”, but you’re still not moving, it’s time for a clutch replacement. Brent Ackley and George Vondriska show you how to take out the drive shaft and unbolt a majority of the transmission on your car’s engine to remove and replace the clutch.
Watch Now >> -
1:48Gapping the Points on Your Car Engine
George Vondriska teaches you how to find the correct gaps between points on your car engine. He starts by showing you how to create the largest gap possible between points. This will not give you the perfect gap, but allows for your classic car to run. Then, he teaches you how to maneuver the gaps to find the perfect…
Watch Now >> -
2:24Classic Car Radiator Cap Performance Test
George Vondriska teaches how to use a pressurized device to test the performance of your classic car’s radiator system and radiator cap to prevent the parts from leaking. Also see how this technique prevents the engine of your classic car from overheating.
Watch Now >> -
9:33Replacing a Differential Gasket
Brent Ackley gives you step-by-step instructions for replacing a differential gasket on a 1966 Buick Skylark classic car. Although it may be a bit messy, you will want to know how to do this because the differential gaskets are what make the wheels go round.
Watch Now >>
