Proper setup of your MIG welding equipment is the first step in achieving good MIG welds. Metal fabricator Gary Simpson demonstrates how to setup your welder, shielding gas, your workspace, and replace consumables on your welder.
Tags: classic car welding, Member Videos, mig welding demo, mig welding how-to, mig welding tips, welding a classic car, welding car parts, welding videos
You Might Also Enjoy...
-
12:25Craig Hopkins provides helpful tips for restoring a classic car in this video. He explains that it is imperative the doors on a classic car are lined up before installing the fenders because that’s what the fenders are going to fit. The control bolt will then set the height of fender to height of door
Watch Now >> -
3:30Since you will butt weld the new quarter panel to the roof and existing quarter panel, Craig Hopkins teaches you how to remove a quarter of an inch from the roof without cutting through the existing car quarter panel. Then, he’ll apply some weld through primer to the step you just created and rest the
Watch Now >> -
2:39Classic car detailing has never been easier! Brent Ackley and George Vondriska teach you how to clean the engine compartment on a 1956 Chevy 210. After a reasonable power wash, scuff sand, prime and paint, the engine compartment on your classic car should look ready for the showroom.
Watch Now >> -
1:28A sheet metal shrinker/stretcher is perfect for any type of metal fabrication you need for your classic car, and it keeps the metal completely flat (without crimps). Mark Oja gives a brief demonstration on how the stretcher works and then shows you an example of a finished product.
Watch Now >>
