Learn how to replace rotors with proper preparation of the rotors by greasing the wheel bearings prior to install. George Vondriska and Brent Ackley show you a way to grease the wheel bearings differently than the way you may be used to doing it. Also learn about a seal seat kit that helps seat the seal.
Tags: Premium Videos
You Might Also Enjoy...
-
2:37George Vondriska explains that malfunctioning cruise control comes from a broken brake switch and it can be a real cheap and easy fix as long as you know you way around a dashboard. Use these helpful tips provided in this video to go through a brake switch replacement for your classic car with ease!
Watch Now >> -
2:06Bleeding the master cylinder can be done with it in the car but it would take a long time to get all the air worked out. Brent Ackley shows you how to bench bleed a master cylinder by using bleeding ports, attaching little hoses and adding brake fluid. Last step is pumping the actuating rod
Watch Now >> -
1:12Craig Hopkins quickly teaches you how to use a clamp and a rubber mallet to remove an emergency brake cable from its holding in the floor of a car body.
Watch Now >> -
35:07While front disc brake conversions are popular on classic cars, rear brakes can be equally as important and should not be overlooked. Mark Simpson takes us through the process to remove the original rear drums and hardware from our project ’57 DeSoto, including the use of a drum puller. Then starting with a clean slate
Watch Now >>
