There are times when drilling holes you simply can’t afford to have metal shavings falling onto painted surfaces or into places the shouldn’t be. Mark Simpson demonstrates this time tested machinist practice to keep the metal filings exactly where you want them.
You Might Also Enjoy...
-
0:59Aligning Valve Cover Gaskets With Bolt Holes
Very rarely do the gasket holes line up with bolt holes when you are replacing valve cover gaskets. Brent Ackley teaches a helpful trick to properly align these holes. Use this method to make sure you have a good seal.
Watch Now >> -
2:02Full Car Floor Installation and Finishing
Add the finishing touches to your full car floor installation with Craig Hopkins. He tells you that the plug welds don’t necessarily have to be ground down, but if you’re going to what tools to use. He uses a cut off wheel with a 3/8th wide rock and 3 inch angle grinder with a 36…
Watch Now >> -
3:161956 Chevy 150 Complete Auto Repair Overview
George Vondriska and Brent Ackley give you a brief rundown of the 1956 Chevrolet 150 that Brent brought into the shop for a complete auto repair. Before they get started on fixing up the classic car, the guys talk about some of the specifications of this model and discuss a few of the cost-effective ways…
Watch Now >> -
1:04How to Sharpen a Chisel
Craig Hopkins teaches you how to sharpen a chisel on a bench grinder with ease in this video. To get a single edge chisel, you simply lay it on the stone and create a sharp edge and a cup.
Watch Now >>
