Building the “Form and Clamp” for our hammer forming project requires just some simple hand tools. Mark Simpson takes us through the process of cutting and sanding to achieve a high quality form.
-
3:30
Trial Fitting on the Classic Car Quarter Panel
Since you will butt weld the new quarter panel to the roof and existing quarter panel, Craig Hopkins teaches you how to remove a quarter of an inch from the roof without cutting through the existing car quarter panel. Then, he’ll apply some weld through primer to the step you just created and rest the…
Watch Now >> -
5:18
Project Car Buying Advice
Buying a car to restore may not be as stressful as looking for a new project car, but there are still important aspects to look for. Brent Ackley tells you what areas to examine to get the finished product you desire depending on how much money you want to spend and the amount of time…
Watch Now >> -
7:41
Classic Car Polishing Preparation
Craig Hopkins prepares you to polish your classic car with 1000, 1500, and 3000 grit sandpaper without scratching the paint, and then shows you the sanding technique with paint sticks, blocks, and a water blade to get the perfect finish. Make sure all of your equipment is clean!
Watch Now >> -
2:13
Final Classic Car Restoration Tips
Craig Hopkins gives you some final classic car restoration tips to finish sanding, buffing, and polishing. You will learn how to run some tape along the edge of the quarter panel (and deck lid) to avoid cutting the paint. Also, all good paint jobs start with a good block. Craig recommends John Wheeler’s Adjustable Flexible…
Watch Now >>