Craig Hopkins and Randy Bolig take you through a classic car quarter panel removal process. First, they outline with a black marker what they are going to cut out of a 1969 Dodge Dart. Then they use a torch and brush to get lead out of the car, which shows them exactly where to cut. Don’t wear synthetic clothing during this process!
You Might Also Enjoy...
-
7:41Classic Car Polishing Preparation
Craig Hopkins prepares you to polish your classic car with 1000, 1500, and 3000 grit sandpaper without scratching the paint, and then shows you the sanding technique with paint sticks, blocks, and a water blade to get the perfect finish. Make sure all of your equipment is clean!
Watch Now >> -
8:49How to Sand a Car: DA Sanding
Craig Hopkins demonstrates how to sand a car fender using a small, tight orbit DA with a cushion pad. This allows for a nice flow rate that makes the sanding really smooth and gives the classic car a clean finish. Make sure to be just as careful Craig when sanding around the edges so you…
Watch Now >> -
2:13Final Classic Car Restoration Tips
Craig Hopkins gives you some final classic car restoration tips to finish sanding, buffing, and polishing. You will learn how to run some tape along the edge of the quarter panel (and deck lid) to avoid cutting the paint. Also, all good paint jobs start with a good block. Craig recommends John Wheeler’s Adjustable Flexible…
Watch Now >> -
16:01How to Use a Bead Roller and Skates on Your Classic Car
The Bead Roller is a handy tool that provides extra strength by adding ridges to your sheet metal. Mark Oja and Cam Benty demonstrate how to use a Bead Roller on your classic car to add a little extra flair and strength to any metal you have.
Watch Now >>
