Craig Hopkins emphasizes the importance of supporting a classic car under its suspension pick up points to make sure it is stable before beginning your classic car restoration. He recommends only doing one panel at a time, and then teaches you how to align the door and replace a hinge.
You Might Also Enjoy...
-
18:30How to Sand a Car: Hand Sanding
Craig Hopkins explains how to sand a car with a paint stick around the edges without making a flat spot. He uses the water blade to distinguish where to sand more and where not to over sand. You will get an up close look on how to properly sand every difficult area, crease, and edge.
Watch Now >> -
12:05Classic Car Restoration: Cut-Down Techniques
Craig Hopkins gives you different tips and tricks to help cut down the metal on a classic car panel without damaging the base. You must make sure to push the metal over weld, rather than attacking it, to avoid tearing the base metal. You will also learn how to get spot welds out. Use this…
Watch Now >> -
6:41Classic Car Quarter Panel Removal
Craig Hopkins and Randy Bolig take you through a classic car quarter panel removal process. First, they outline with a black marker what they are going to cut out of a 1969 Dodge Dart. Then they use a torch and brush to get lead out of the car, which shows them exactly where to cut.…
Watch Now >> -
5:24Installing an Air Dam in a Classic Car
For most classic cars, an air dam is used to help the car breathe better, but Mark Oja uses one on his GT 500 to make it look even cooler. Whatever your purpose, this video will teach you how to install an air dam into a classic car.
Watch Now >>
