Learn how to cut and install a small door patch for your hot rod. We walk you through the entire step-by-step process, showing you how to cut the shape, weld it into place, and grind your welding down until the area is smooth and the patch is utterly unnoticeable.
You Might Also Enjoy...
-
12:47Classic Car Detailing: Buffing
Buffing is the number one step done with a wool pad and the perfect fit system compound. Craig Hopkins provides helpful car detailing tips in this video. Also, he shows you how to clean your buffer and cut the panels by orienting the angle of the buffer, and then shows you where to put the…
Watch Now >> -
8:49How to Sand a Car: DA Sanding
Craig Hopkins demonstrates how to sand a car fender using a small, tight orbit DA with a cushion pad. This allows for a nice flow rate that makes the sanding really smooth and gives the classic car a clean finish. Make sure to be just as careful Craig when sanding around the edges so you…
Watch Now >> -
3:30Trial Fitting on the Classic Car Quarter Panel
Since you will butt weld the new quarter panel to the roof and existing quarter panel, Craig Hopkins teaches you how to remove a quarter of an inch from the roof without cutting through the existing car quarter panel. Then, he’ll apply some weld through primer to the step you just created and rest the…
Watch Now >> -
12:25Restoring a Classic Car: Installing Fenders
Craig Hopkins provides helpful tips for restoring a classic car in this video. He explains that it is imperative the doors on a classic car are lined up before installing the fenders because that’s what the fenders are going to fit. The control bolt will then set the height of fender to height of door…
Watch Now >>
