Craig Hopkins has the rocker in place and continues to cut out the damaged area of the panel. He shows us how to prep when working with body patch panels. Continue on with this series and watch how to install the new patch panel.
You Might Also Enjoy...
-
3:30Trial Fitting on the Classic Car Quarter Panel
Since you will butt weld the new quarter panel to the roof and existing quarter panel, Craig Hopkins teaches you how to remove a quarter of an inch from the roof without cutting through the existing car quarter panel. Then, he’ll apply some weld through primer to the step you just created and rest the…
Watch Now >> -
1:28Sheet Metal Shrinker/Stretcher For Your Classic Car
A sheet metal shrinker/stretcher is perfect for any type of metal fabrication you need for your classic car, and it keeps the metal completely flat (without crimps). Mark Oja gives a brief demonstration on how the stretcher works and then shows you an example of a finished product.
Watch Now >> -
6:36Welding the Wheel Panel on Your Project Car
Craig Hopkins teaches you how to fit and weld the wheel panel on your project car in the wheelhouse. He uses a spot welder even though a plug weld works just as well for this type of job.
Watch Now >> -
2:39Classic Car Detailing: Cleaning the Engine Compartment
Classic car detailing has never been easier! Brent Ackley and George Vondriska teach you how to clean the engine compartment on a 1956 Chevy 210. After a reasonable power wash, scuff sand, prime and paint, the engine compartment on your classic car should look ready for the showroom.
Watch Now >>
