Craig Hopkins provides you with awesome welding basics while he gets you off the tool bench and welds a floorpan into a classic car. He starts by applying a RS512 primer by Rubberseal that will give you a longer lasting repair, and then teaches you how to tightly and safely clamp the floorpan down.
-
12:25
Restoring a Classic Car: Installing Fenders
Craig Hopkins provides helpful tips for restoring a classic car in this video. He explains that it is imperative the doors on a classic car are lined up before installing the fenders because that’s what the fenders are going to fit. The control bolt will then set the height of fender to height of door…
Watch Now >> -
2:39
Classic Car Detailing: Cleaning the Engine Compartment
Classic car detailing has never been easier! Brent Ackley and George Vondriska teach you how to clean the engine compartment on a 1956 Chevy 210. After a reasonable power wash, scuff sand, prime and paint, the engine compartment on your classic car should look ready for the showroom.
Watch Now >> -
12:05
Classic Car Restoration: Cut-Down Techniques
Craig Hopkins gives you different tips and tricks to help cut down the metal on a classic car panel without damaging the base. You must make sure to push the metal over weld, rather than attacking it, to avoid tearing the base metal. You will also learn how to get spot welds out. Use this…
Watch Now >> -
3:30
Trial Fitting on the Classic Car Quarter Panel
Since you will butt weld the new quarter panel to the roof and existing quarter panel, Craig Hopkins teaches you how to remove a quarter of an inch from the roof without cutting through the existing car quarter panel. Then, he’ll apply some weld through primer to the step you just created and rest the…
Watch Now >>