Craig Hopkins teaches you how to properly use and take care of a welder. Personally, he likes to work with the gas gauge on 30, but for better puddle control you’ll work on 20. No matter what type of welder you have, make sure to maintain a nice gentle loop in all of the cords and keep the tip clean.
Tags: Premium Videos
You Might Also Enjoy...
-
12:05Craig Hopkins gives you different tips and tricks to help cut down the metal on a classic car panel without damaging the base. You must make sure to push the metal over weld, rather than attacking it, to avoid tearing the base metal. You will also learn how to get spot welds out. Use this
Watch Now >> -
3:34Craig Hopkins introduces the car tools you will need to install front sheet metal to your classic car. Some of the equipment you will need includes a ratcheting strap, screw driver, wrench, ratchet, sockets, hammer and pick bar. New hinges will also help make the hood fall in the same place every time.
Watch Now >> -
2:13Craig Hopkins gives you some final classic car restoration tips to finish sanding, buffing, and polishing. You will learn how to run some tape along the edge of the quarter panel (and deck lid) to avoid cutting the paint. Also, all good paint jobs start with a good block. Craig recommends John Wheeler’s Adjustable Flexible
Watch Now >> -
12:25Craig Hopkins provides helpful tips for restoring a classic car in this video. He explains that it is imperative the doors on a classic car are lined up before installing the fenders because that’s what the fenders are going to fit. The control bolt will then set the height of fender to height of door
Watch Now >>
