Craig Hopkins teaches you how to create a plug weld while installing a floorpan. You will need to make sure the top pan is dropped all the way down tight on the base metal of the car. It is essential when clamping that you make it both tight and right next to the weld. You will also learn tricks such as clamping the metal with a screw and welding up the center of the pan so it doesn’t flex. Use this helpful welding tips provided to enhance your classic car.
You Might Also Enjoy
-
5:24Installing an Air Dam in a Classic Car
For most classic cars, an air dam is used to help the car breathe better, but Mark Oja uses one on his GT 500 to make it look even cooler. Whatever your purpose, this video will teach you how to install an air dam into a classic car.
Watch Now >> -
7:41Classic Car Polishing Preparation
Craig Hopkins prepares you to polish your classic car with 1000, 1500, and 3000 grit sandpaper without scratching the paint, and then shows you the sanding technique with paint sticks, blocks, and a water blade to get the perfect finish. Make sure all of your equipment is clean!
Watch Now >> -
9:32Classic Car Quarter Panel Final and Welding
Craig Hopkins runs down a checklist on how a car quarter panel should fit on your classic car, including using plenty of clamps and securing it with a final welding and rock grinder to level it out for a perfect repair.
Watch Now >> -
1:28Sheet Metal Shrinker/Stretcher For Your Classic Car
A sheet metal shrinker/stretcher is perfect for any type of metal fabrication you need for your classic car, and it keeps the metal completely flat (without crimps). Mark Oja gives a brief demonstration on how the stretcher works and then shows you an example of a finished product.
Watch Now >>
