Craig Hopkins explains that to when doing the car floor welding you need to play with the settings. For example, hold the welder higher for heavier settings. Both metals are together if you are able to hear it ring. Also, get a tip about utilizing plug weld holes to run a screw into, which makes one less hole to weld.
You Might Also Enjoy...
-
5:24Installing an Air Dam in a Classic Car
For most classic cars, an air dam is used to help the car breathe better, but Mark Oja uses one on his GT 500 to make it look even cooler. Whatever your purpose, this video will teach you how to install an air dam into a classic car.
Watch Now >> -
18:30How to Sand a Car: Hand Sanding
Craig Hopkins explains how to sand a car with a paint stick around the edges without making a flat spot. He uses the water blade to distinguish where to sand more and where not to over sand. You will get an up close look on how to properly sand every difficult area, crease, and edge.
Watch Now >> -
2:13Final Classic Car Restoration Tips
Craig Hopkins gives you some final classic car restoration tips to finish sanding, buffing, and polishing. You will learn how to run some tape along the edge of the quarter panel (and deck lid) to avoid cutting the paint. Also, all good paint jobs start with a good block. Craig recommends John Wheeler’s Adjustable Flexible…
Watch Now >> -
12:47Classic Car Detailing: Buffing
Buffing is the number one step done with a wool pad and the perfect fit system compound. Craig Hopkins provides helpful car detailing tips in this video. Also, he shows you how to clean your buffer and cut the panels by orienting the angle of the buffer, and then shows you where to put the…
Watch Now >>
