Craig Hopkins introduces the car tools you will need to install front sheet metal to your classic car. Some of the equipment you will need includes a ratcheting strap, screw driver, wrench, ratchet, sockets, hammer and pick bar. New hinges will also help make the hood fall in the same place every time.
You Might Also Enjoy
-
12:25Restoring a Classic Car: Installing Fenders
Craig Hopkins provides helpful tips for restoring a classic car in this video. He explains that it is imperative the doors on a classic car are lined up before installing the fenders because that’s what the fenders are going to fit. The control bolt will then set the height of fender to height of door…
Watch Now >> -
2:13Final Classic Car Restoration Tips
Craig Hopkins gives you some final classic car restoration tips to finish sanding, buffing, and polishing. You will learn how to run some tape along the edge of the quarter panel (and deck lid) to avoid cutting the paint. Also, all good paint jobs start with a good block. Craig recommends John Wheeler’s Adjustable Flexible…
Watch Now >> -
3:30Trial Fitting on the Classic Car Quarter Panel
Since you will butt weld the new quarter panel to the roof and existing quarter panel, Craig Hopkins teaches you how to remove a quarter of an inch from the roof without cutting through the existing car quarter panel. Then, he’ll apply some weld through primer to the step you just created and rest the…
Watch Now >> -
5:29Restoring a Classic Car: Installing the Hinges and Hood
Installing hinges on classic car doors is a pretty self-explanatory process, but Craig Hopkins teaches you some tricks to make restoring a classic car even easier, such as putting the back bolt in first and then coming to the front bolt. While installing the hinges and hood, you will want to be in the middle…
Watch Now >>
