This video covers rocker panel repair and prepping for a body patch panel. Craig Hopkins dollies the door and shares with us that the rocker panel is no good we’ll need to replace it. Continue on with this series with the next video on removing the damaged section of the quarter panel.
You Might Also Enjoy...
-
1:04How to Sharpen a Chisel
Craig Hopkins teaches you how to sharpen a chisel on a bench grinder with ease in this video. To get a single edge chisel, you simply lay it on the stone and create a sharp edge and a cup.
Watch Now >> -
8:49How to Sand a Car: DA Sanding
Craig Hopkins demonstrates how to sand a car fender using a small, tight orbit DA with a cushion pad. This allows for a nice flow rate that makes the sanding really smooth and gives the classic car a clean finish. Make sure to be just as careful Craig when sanding around the edges so you…
Watch Now >> -
12:25Restoring a Classic Car: Installing Fenders
Craig Hopkins provides helpful tips for restoring a classic car in this video. He explains that it is imperative the doors on a classic car are lined up before installing the fenders because that’s what the fenders are going to fit. The control bolt will then set the height of fender to height of door…
Watch Now >> -
3:30Trial Fitting on the Classic Car Quarter Panel
Since you will butt weld the new quarter panel to the roof and existing quarter panel, Craig Hopkins teaches you how to remove a quarter of an inch from the roof without cutting through the existing car quarter panel. Then, he’ll apply some weld through primer to the step you just created and rest the…
Watch Now >>
