Understanding how metal deforms is the first step toward straightening it. Mark Simpson explains the process of using a hammer and dolly set to remove dents and straighten metal.
You Might Also Enjoy...
-
3:30Trial Fitting on the Classic Car Quarter Panel
Since you will butt weld the new quarter panel to the roof and existing quarter panel, Craig Hopkins teaches you how to remove a quarter of an inch from the roof without cutting through the existing car quarter panel. Then, he’ll apply some weld through primer to the step you just created and rest the…
Watch Now >> -
9:12Classic Car Detailing: Polishing
Craig Hopkins uses a 3M polishing compound with a black foam pad to polish a classic car. and give it a stunning glass-like finish. Learn how to use Craig’s technique of barely brushing down on the edges to make sure you don’t cut the paint. Use these helpful car detailing tips today and see how…
Watch Now >> -
12:05Classic Car Restoration: Cut-Down Techniques
Craig Hopkins gives you different tips and tricks to help cut down the metal on a classic car panel without damaging the base. You must make sure to push the metal over weld, rather than attacking it, to avoid tearing the base metal. You will also learn how to get spot welds out. Use this…
Watch Now >> -
6:41Classic Car Quarter Panel Removal
Craig Hopkins and Randy Bolig take you through a classic car quarter panel removal process. First, they outline with a black marker what they are going to cut out of a 1969 Dodge Dart. Then they use a torch and brush to get lead out of the car, which shows them exactly where to cut.…
Watch Now >>
