Craig Hopkins provides helpful insight into the different types of welders available. He helps you decide what type of welder to buy by reviewing a 110 tap unit and a 220V 175 gas shielded unit. He recommends the 220V unit over the 210V, but discusses how both will get the job done. Just don’t get a flux core!
You Might Also Enjoy
-
12:05Classic Car Restoration: Cut-Down Techniques
Craig Hopkins gives you different tips and tricks to help cut down the metal on a classic car panel without damaging the base. You must make sure to push the metal over weld, rather than attacking it, to avoid tearing the base metal. You will also learn how to get spot welds out. Use this…
Watch Now >> -
3:30Trial Fitting on the Classic Car Quarter Panel
Since you will butt weld the new quarter panel to the roof and existing quarter panel, Craig Hopkins teaches you how to remove a quarter of an inch from the roof without cutting through the existing car quarter panel. Then, he’ll apply some weld through primer to the step you just created and rest the…
Watch Now >> -
2:13Final Classic Car Restoration Tips
Craig Hopkins gives you some final classic car restoration tips to finish sanding, buffing, and polishing. You will learn how to run some tape along the edge of the quarter panel (and deck lid) to avoid cutting the paint. Also, all good paint jobs start with a good block. Craig recommends John Wheeler’s Adjustable Flexible…
Watch Now >> -
6:41Classic Car Quarter Panel Removal
Craig Hopkins and Randy Bolig take you through a classic car quarter panel removal process. First, they outline with a black marker what they are going to cut out of a 1969 Dodge Dart. Then they use a torch and brush to get lead out of the car, which shows them exactly where to cut.…
Watch Now >>
