Craig Hopkins will present more welding basics in this video. Craig with also teach you how to recognize if the wire on a welder is to fast or to slow, how to balance the heat range and wire speed, and where to position your hand when welding. Learn what is happening while you weld and why you need to adjust the settings.
Tags: Premium Videos
You Might Also Enjoy...
-
3:34Craig Hopkins introduces the car tools you will need to install front sheet metal to your classic car. Some of the equipment you will need includes a ratcheting strap, screw driver, wrench, ratchet, sockets, hammer and pick bar. New hinges will also help make the hood fall in the same place every time.
Watch Now >> -
18:30Craig Hopkins explains how to sand a car with a paint stick around the edges without making a flat spot. He uses the water blade to distinguish where to sand more and where not to over sand. You will get an up close look on how to properly sand every difficult area, crease, and edge.
Watch Now >> -
9:32Craig Hopkins runs down a checklist on how a car quarter panel should fit on your classic car, including using plenty of clamps and securing it with a final welding and rock grinder to level it out for a perfect repair.
Watch Now >> -
1:28A sheet metal shrinker/stretcher is perfect for any type of metal fabrication you need for your classic car, and it keeps the metal completely flat (without crimps). Mark Oja gives a brief demonstration on how the stretcher works and then shows you an example of a finished product.
Watch Now >>
