Now that the back of the 1967 Chevy Chevelle is welded to perfection, it is time to weld the front of the car. Craig Hopkins demonstrates fitting the covers on the front side while teaching you how to clamp in the dashboard correctly. Go through the welding process with Craig and be confident in your welding skills.
-
9:32
Classic Car Quarter Panel Final and Welding
Craig Hopkins runs down a checklist on how a car quarter panel should fit on your classic car, including using plenty of clamps and securing it with a final welding and rock grinder to level it out for a perfect repair.
Watch Now >> -
5:24
Installing an Air Dam in a Classic Car
For most classic cars, an air dam is used to help the car breathe better, but Mark Oja uses one on his GT 500 to make it look even cooler. Whatever your purpose, this video will teach you how to install an air dam into a classic car.
Watch Now >> -
1:28
Sheet Metal Shrinker/Stretcher For Your Classic Car
A sheet metal shrinker/stretcher is perfect for any type of metal fabrication you need for your classic car, and it keeps the metal completely flat (without crimps). Mark Oja gives a brief demonstration on how the stretcher works and then shows you an example of a finished product.
Watch Now >> -
18:30
How to Sand a Car: Hand Sanding
Craig Hopkins explains how to sand a car with a paint stick around the edges without making a flat spot. He uses the water blade to distinguish where to sand more and where not to over sand. You will get an up close look on how to properly sand every difficult area, crease, and edge.
Watch Now >>