Craig Hopkins prepares you to polish your classic car with 1000, 1500, and 3000 grit sandpaper without scratching the paint, and then shows you the sanding technique with paint sticks, blocks, and a water blade to get the perfect finish. Make sure all of your equipment is clean!
You Might Also Enjoy...
-
2:13Final Classic Car Restoration Tips
Craig Hopkins gives you some final classic car restoration tips to finish sanding, buffing, and polishing. You will learn how to run some tape along the edge of the quarter panel (and deck lid) to avoid cutting the paint. Also, all good paint jobs start with a good block. Craig recommends John Wheeler’s Adjustable Flexible…
Watch Now >> -
9:32Classic Car Quarter Panel Final and Welding
Craig Hopkins runs down a checklist on how a car quarter panel should fit on your classic car, including using plenty of clamps and securing it with a final welding and rock grinder to level it out for a perfect repair.
Watch Now >> -
2:39Classic Car Detailing: Cleaning the Engine Compartment
Classic car detailing has never been easier! Brent Ackley and George Vondriska teach you how to clean the engine compartment on a 1956 Chevy 210. After a reasonable power wash, scuff sand, prime and paint, the engine compartment on your classic car should look ready for the showroom.
Watch Now >> -
18:30How to Sand a Car: Hand Sanding
Craig Hopkins explains how to sand a car with a paint stick around the edges without making a flat spot. He uses the water blade to distinguish where to sand more and where not to over sand. You will get an up close look on how to properly sand every difficult area, crease, and edge.
Watch Now >>
