Craig Hopkins quarter panel has nice shape, but the door is too tight on the back now. While he provides you with helpful car repair tips, he will help you make the two parallel and on the same plane by fixing the quarter panel height to meet the door plane. You will do this by adding metal to the back edge to the door through welding.
-
3:30
Trial Fitting on the Classic Car Quarter Panel
Since you will butt weld the new quarter panel to the roof and existing quarter panel, Craig Hopkins teaches you how to remove a quarter of an inch from the roof without cutting through the existing car quarter panel. Then, he’ll apply some weld through primer to the step you just created and rest the…
Watch Now >> -
5:24
Installing an Air Dam in a Classic Car
For most classic cars, an air dam is used to help the car breathe better, but Mark Oja uses one on his GT 500 to make it look even cooler. Whatever your purpose, this video will teach you how to install an air dam into a classic car.
Watch Now >> -
18:30
How to Sand a Car: Hand Sanding
Craig Hopkins explains how to sand a car with a paint stick around the edges without making a flat spot. He uses the water blade to distinguish where to sand more and where not to over sand. You will get an up close look on how to properly sand every difficult area, crease, and edge.
Watch Now >> -
12:05
Classic Car Restoration: Cut-Down Techniques
Craig Hopkins gives you different tips and tricks to help cut down the metal on a classic car panel without damaging the base. You must make sure to push the metal over weld, rather than attacking it, to avoid tearing the base metal. You will also learn how to get spot welds out. Use this…
Watch Now >>