Craig Hopkins is in the garage working on his ’67 Chevelle and walks through the process of how to hang a door and fender correctly. See how he uses a block of wood to support the door and find out what tools he uses for this particular step. Use these helpful tips and techniques today and learn how to hang a door and fender.
You Might Also Enjoy...
-
12:25Restoring a Classic Car: Installing Fenders
Craig Hopkins provides helpful tips for restoring a classic car in this video. He explains that it is imperative the doors on a classic car are lined up before installing the fenders because that’s what the fenders are going to fit. The control bolt will then set the height of fender to height of door…
Watch Now >> -
18:30How to Sand a Car: Hand Sanding
Craig Hopkins explains how to sand a car with a paint stick around the edges without making a flat spot. He uses the water blade to distinguish where to sand more and where not to over sand. You will get an up close look on how to properly sand every difficult area, crease, and edge.
Watch Now >> -
12:47Classic Car Detailing: Buffing
Buffing is the number one step done with a wool pad and the perfect fit system compound. Craig Hopkins provides helpful car detailing tips in this video. Also, he shows you how to clean your buffer and cut the panels by orienting the angle of the buffer, and then shows you where to put the…
Watch Now >> -
8:49How to Sand a Car: DA Sanding
Craig Hopkins demonstrates how to sand a car fender using a small, tight orbit DA with a cushion pad. This allows for a nice flow rate that makes the sanding really smooth and gives the classic car a clean finish. Make sure to be just as careful Craig when sanding around the edges so you…
Watch Now >>
