Craig Hopkins demonstrates how to sand a car fender using a small, tight orbit DA with a cushion pad. This allows for a nice flow rate that makes the sanding really smooth and gives the classic car a clean finish. Make sure to be just as careful Craig when sanding around the edges so you don’t burn through the clear.
You Might Also Enjoy...
-
12:47Classic Car Detailing: Buffing
Buffing is the number one step done with a wool pad and the perfect fit system compound. Craig Hopkins provides helpful car detailing tips in this video. Also, he shows you how to clean your buffer and cut the panels by orienting the angle of the buffer, and then shows you where to put the…
Watch Now >> -
0:56Replacing Bolts on Classic Muscle Cars
Because classic muscle cars are usually older, their owners typically have to replace bolts more often than those of modern cars. Mark Oja teaches you two ways to do so, with one being more costly than the other. Once you determine that the bolts you removed are correct, Mark suggests buying a complete bolt replacement…
Watch Now >> -
5:24Installing an Air Dam in a Classic Car
For most classic cars, an air dam is used to help the car breathe better, but Mark Oja uses one on his GT 500 to make it look even cooler. Whatever your purpose, this video will teach you how to install an air dam into a classic car.
Watch Now >> -
12:05Classic Car Restoration: Cut-Down Techniques
Craig Hopkins gives you different tips and tricks to help cut down the metal on a classic car panel without damaging the base. You must make sure to push the metal over weld, rather than attacking it, to avoid tearing the base metal. You will also learn how to get spot welds out. Use this…
Watch Now >>
