In the next step of our 1967 Chevy Chevelle rebuild, Craig Hopkins demonstrates the step-by-step process for mounting and spot-welding inner and outer wheel houses. He teaches you each of the necessary fitting, clamping and welding techniques, and talks you through every step so you can be confident you know what you’re doing.
You Might Also Enjoy
-
16:01How to Use a Bead Roller and Skates on Your Classic Car
The Bead Roller is a handy tool that provides extra strength by adding ridges to your sheet metal. Mark Oja and Cam Benty demonstrate how to use a Bead Roller on your classic car to add a little extra flair and strength to any metal you have.
Watch Now >> -
3:34Essential Car Tools
Craig Hopkins introduces the car tools you will need to install front sheet metal to your classic car. Some of the equipment you will need includes a ratcheting strap, screw driver, wrench, ratchet, sockets, hammer and pick bar. New hinges will also help make the hood fall in the same place every time.
Watch Now >> -
6:36Welding the Wheel Panel on Your Project Car
Craig Hopkins teaches you how to fit and weld the wheel panel on your project car in the wheelhouse. He uses a spot welder even though a plug weld works just as well for this type of job.
Watch Now >> -
12:05Classic Car Restoration: Cut-Down Techniques
Craig Hopkins gives you different tips and tricks to help cut down the metal on a classic car panel without damaging the base. You must make sure to push the metal over weld, rather than attacking it, to avoid tearing the base metal. You will also learn how to get spot welds out. Use this…
Watch Now >>
