Craig Hopkins gives us an idea of what he will cover during the installing patch panels video series. He will show us how to replace a small patch on a door, a large patch on a rear quarter and one on a fender.
You Might Also Enjoy...
-
2:39Classic Car Detailing: Cleaning the Engine Compartment
Classic car detailing has never been easier! Brent Ackley and George Vondriska teach you how to clean the engine compartment on a 1956 Chevy 210. After a reasonable power wash, scuff sand, prime and paint, the engine compartment on your classic car should look ready for the showroom.
Watch Now >> -
6:36Welding the Wheel Panel on Your Project Car
Craig Hopkins teaches you how to fit and weld the wheel panel on your project car in the wheelhouse. He uses a spot welder even though a plug weld works just as well for this type of job.
Watch Now >> -
12:05Classic Car Restoration: Cut-Down Techniques
Craig Hopkins gives you different tips and tricks to help cut down the metal on a classic car panel without damaging the base. You must make sure to push the metal over weld, rather than attacking it, to avoid tearing the base metal. You will also learn how to get spot welds out. Use this…
Watch Now >> -
12:25Restoring a Classic Car: Installing Fenders
Craig Hopkins provides helpful tips for restoring a classic car in this video. He explains that it is imperative the doors on a classic car are lined up before installing the fenders because that’s what the fenders are going to fit. The control bolt will then set the height of fender to height of door…
Watch Now >>
