Craig Hopkins talks about a tool that he prefers to make the perfect panel – a 9 tooth body file. This sharp tool gives you control to sheer the metal off your classic car. It creates the perfect plane that gives a nice smooth radius. So add a great finish to your corners and more importantly a good, natural look for your classic car.
You Might Also Enjoy
-
12:25Restoring a Classic Car: Installing Fenders
Craig Hopkins provides helpful tips for restoring a classic car in this video. He explains that it is imperative the doors on a classic car are lined up before installing the fenders because that’s what the fenders are going to fit. The control bolt will then set the height of fender to height of door…
Watch Now >> -
8:49How to Sand a Car: DA Sanding
Craig Hopkins demonstrates how to sand a car fender using a small, tight orbit DA with a cushion pad. This allows for a nice flow rate that makes the sanding really smooth and gives the classic car a clean finish. Make sure to be just as careful Craig when sanding around the edges so you…
Watch Now >> -
5:18Project Car Buying Advice
Buying a car to restore may not be as stressful as looking for a new project car, but there are still important aspects to look for. Brent Ackley tells you what areas to examine to get the finished product you desire depending on how much money you want to spend and the amount of time…
Watch Now >> -
12:05Classic Car Restoration: Cut-Down Techniques
Craig Hopkins gives you different tips and tricks to help cut down the metal on a classic car panel without damaging the base. You must make sure to push the metal over weld, rather than attacking it, to avoid tearing the base metal. You will also learn how to get spot welds out. Use this…
Watch Now >>
