Learning to straighten sheet metal efficiently take a little practice, however the tools used are relatively inexpensive and guaranteed to pay for them selves. Mark Simpson introduces us to the most common hammers and dollies and explains their use in the metal straightening process.
You Might Also Enjoy
-
12:05Classic Car Restoration: Cut-Down Techniques
Craig Hopkins gives you different tips and tricks to help cut down the metal on a classic car panel without damaging the base. You must make sure to push the metal over weld, rather than attacking it, to avoid tearing the base metal. You will also learn how to get spot welds out. Use this…
Watch Now >> -
0:56Replacing Bolts on Classic Muscle Cars
Because classic muscle cars are usually older, their owners typically have to replace bolts more often than those of modern cars. Mark Oja teaches you two ways to do so, with one being more costly than the other. Once you determine that the bolts you removed are correct, Mark suggests buying a complete bolt replacement…
Watch Now >> -
2:10Classic Car Sanding Supplies in Your Shop
Sanding is a critical step in adding an impressive paint job to your classic car, so you need the proper supplies in your shop. Cam Benty helps you choose what size blocks to use, how to build your own block and the functions of a powder can. A proper finish starts with the car sanding…
Watch Now >> -
18:30How to Sand a Car: Hand Sanding
Craig Hopkins explains how to sand a car with a paint stick around the edges without making a flat spot. He uses the water blade to distinguish where to sand more and where not to over sand. You will get an up close look on how to properly sand every difficult area, crease, and edge.
Watch Now >>
