Craig Hopkins gives you different tips and tricks to help cut down the metal on a classic car panel without damaging the base. You must make sure to push the metal over weld, rather than attacking it, to avoid tearing the base metal. You will also learn how to get spot welds out. Use this technique today and make your classic car restoration process quick and easy!
You Might Also Enjoy
-
16:01How to Use a Bead Roller and Skates on Your Classic Car
The Bead Roller is a handy tool that provides extra strength by adding ridges to your sheet metal. Mark Oja and Cam Benty demonstrate how to use a Bead Roller on your classic car to add a little extra flair and strength to any metal you have.
Watch Now >> -
17:29How to Fix Small Dents on Your Classic Car
Do you hate that little dent on your classic car that you have no idea how it got there? Mark Oja teaches you how to fix small dents on your classic car in this video. Also, find out about the techniques and materials you’ll need to remove those unsightly dings from your classic car for…
Watch Now >> -
18:30How to Sand a Car: Hand Sanding
Craig Hopkins explains how to sand a car with a paint stick around the edges without making a flat spot. He uses the water blade to distinguish where to sand more and where not to over sand. You will get an up close look on how to properly sand every difficult area, crease, and edge.
Watch Now >> -
8:49How to Sand a Car: DA Sanding
Craig Hopkins demonstrates how to sand a car fender using a small, tight orbit DA with a cushion pad. This allows for a nice flow rate that makes the sanding really smooth and gives the classic car a clean finish. Make sure to be just as careful Craig when sanding around the edges so you…
Watch Now >>
