Craig Hopkins shows you how to prepare and set the replacement car floor into place. Beforehand, place a stand underneath the car to pull the back of floor up to same level as the foot weld. You will then learn how to clamp up the car, use drifts to line up holes where seat goes, and use sheet metal screws when you aren’t able to use clamps.
-
6:36
Welding the Wheel Panel on Your Project Car
Craig Hopkins teaches you how to fit and weld the wheel panel on your project car in the wheelhouse. He uses a spot welder even though a plug weld works just as well for this type of job.
Watch Now >> -
2:39
Classic Car Detailing: Cleaning the Engine Compartment
Classic car detailing has never been easier! Brent Ackley and George Vondriska teach you how to clean the engine compartment on a 1956 Chevy 210. After a reasonable power wash, scuff sand, prime and paint, the engine compartment on your classic car should look ready for the showroom.
Watch Now >> -
9:32
Classic Car Quarter Panel Final and Welding
Craig Hopkins runs down a checklist on how a car quarter panel should fit on your classic car, including using plenty of clamps and securing it with a final welding and rock grinder to level it out for a perfect repair.
Watch Now >> -
2:10
Classic Car Sanding Supplies in Your Shop
Sanding is a critical step in adding an impressive paint job to your classic car, so you need the proper supplies in your shop. Cam Benty helps you choose what size blocks to use, how to build your own block and the functions of a powder can. A proper finish starts with the car sanding…
Watch Now >>