Craig Hopkins explains how to sand a car with a paint stick around the edges without making a flat spot. He uses the water blade to distinguish where to sand more and where not to over sand. You will get an up close look on how to properly sand every difficult area, crease, and edge.
You Might Also Enjoy...
-
5:24Installing an Air Dam in a Classic Car
For most classic cars, an air dam is used to help the car breathe better, but Mark Oja uses one on his GT 500 to make it look even cooler. Whatever your purpose, this video will teach you how to install an air dam into a classic car.
Watch Now >> -
12:47Classic Car Detailing: Buffing
Buffing is the number one step done with a wool pad and the perfect fit system compound. Craig Hopkins provides helpful car detailing tips in this video. Also, he shows you how to clean your buffer and cut the panels by orienting the angle of the buffer, and then shows you where to put the…
Watch Now >> -
2:13Final Classic Car Restoration Tips
Craig Hopkins gives you some final classic car restoration tips to finish sanding, buffing, and polishing. You will learn how to run some tape along the edge of the quarter panel (and deck lid) to avoid cutting the paint. Also, all good paint jobs start with a good block. Craig recommends John Wheeler’s Adjustable Flexible…
Watch Now >> -
3:34Essential Car Tools
Craig Hopkins introduces the car tools you will need to install front sheet metal to your classic car. Some of the equipment you will need includes a ratcheting strap, screw driver, wrench, ratchet, sockets, hammer and pick bar. New hinges will also help make the hood fall in the same place every time.
Watch Now >>
