Craig Hopkins teaches you how to sharpen a chisel on a bench grinder with ease in this video. To get a single edge chisel, you simply lay it on the stone and create a sharp edge and a cup.
Tags: Free Videos
You Might Also Enjoy...
-
3:30Since you will butt weld the new quarter panel to the roof and existing quarter panel, Craig Hopkins teaches you how to remove a quarter of an inch from the roof without cutting through the existing car quarter panel. Then, he’ll apply some weld through primer to the step you just created and rest the
Watch Now >> -
2:13Craig Hopkins gives you some final classic car restoration tips to finish sanding, buffing, and polishing. You will learn how to run some tape along the edge of the quarter panel (and deck lid) to avoid cutting the paint. Also, all good paint jobs start with a good block. Craig recommends John Wheeler’s Adjustable Flexible
Watch Now >> -
7:41Craig Hopkins prepares you to polish your classic car with 1000, 1500, and 3000 grit sandpaper without scratching the paint, and then shows you the sanding technique with paint sticks, blocks, and a water blade to get the perfect finish. Make sure all of your equipment is clean!
Watch Now >> -
9:32Craig Hopkins runs down a checklist on how a car quarter panel should fit on your classic car, including using plenty of clamps and securing it with a final welding and rock grinder to level it out for a perfect repair.
Watch Now >>
VERY UNSAFE!! Where is the tool rest? to be safe and protect yourself from grinder wheel explosion should you drop the chisel a tool rest is a must. If this is a commercial shop OSHA will probably be by if they have seen this video.